I went to a craft night that my mom’s neighborhood was doing and I made this adorable Halloween witch wreath. I would LOVE to pass on the information to you so that you can make one as well.
If you would like a quick print out here is my PDF of instructions that I was given when I made my wreath.
Buy all of your supplies:
- 9” or 12” metal wreath ring (picture provided below) (Buy on Amazon – 12 inch Wire Wreath)
- About 20” wide roll of Deco Mesh in the following colors: black, green, purple, orange. (Buy on Amazon – Metallic Poly Deco Mesh
- 5 and 1/2″ wide Deco Mesh Ribbon in yellow.
- Black pipe cleaners, cut into thirds. (Buy on Amazon – Black Pipe Cleaners
- Witch legs (Buy on Amazon – Witch Legs
- Halloween decorative balls
- Decorative spider
- Black Ribbon, 12″ in length
Cut deco mesh in about 10” squares. I cut 10″ stripes and then cut those in half. You will need 25 black, 20 green, 15 purple, and 10 orange. Then cut your yellow decorative mesh (pictured above; not sure what this is even called) into squares or if you can’t find any of that just cut yellow Deco Mesh 5-1/2″ wide into 15″ strips. You will need 5 yellow.
Take deco mesh square bring opposite corners together and then grab in the center of the square; puckering the corners together. Tie black pipe cleaner to the part in your fingers.
Metal ring has 5 sections and 4 rows.
I gather and attach pipe cleaners to all of one color before attaching to metal ring. Use the pipe cleaner to attach the deco mesh to metal ring.
Here is how the colors need to be placed on the metal ring.
5 BLACK in each section of the outer ring.
4 GREEN in each section of the next ring.
3 PURPLE in each section of the next ring.
2 ORANGE in each section of the inner most ring.
The 5 YELLOW pieces should be placed in the green layer on the metal divider for each section.
Once all the Deco Mesh is placed attach witch legs by inserting a piece of 5” metal wire in the felt/fabric that attach the legs together, if they are from Hobby Lobby, like my legs. If you can’t find legs, like mine, you can use the table leg covers (pictured below), stuff with batting and tie on.
I attach the legs on the center of the metal ring on the top of the inner most section. This helps cover where the deco mesh won’t cover. Now fluff the decor mesh to cover the hole in the center.
You now can place decorative balls and a spider or two to the wreath where you like them.
I attached a piece of black ribbon to my wreath so that it would hang lower/easier to my wreath hook. The black ribbon is hidden from view by the black deco mesh.
Pictured below is the wreath with skinny Hobby Lobby legs. Pictured below that is the wreath with the table cover legs. I love both! Any witch legs will do, as long as they are at least 18″ in length. Enjoy!
Happy Crafting!!!
Pinterest Layout